Special Features

Guest PIN Registration

Steps

1. Open battery cover, press [Registration] button and beep sound will be heard
2. Enter pin number followed by [#] button
3. Check if the numbers [1, 2, 3, 4, 5] has been lighted on the number pad. Press [4] button
4. When LED is all lighted, enter guest pin number to be registered. Enter 4~12 digits number and press [#] button
5. Enter guest pin number again. Press [Registration] button and the registration of guest pin number is complete

note

If you register a new guest pin number, the old one will be deleted

note

Only 1 guest pin number can be saved. It will be deleted after 1 usage

Auto / Manual Lock Setting

Dual-mode Security Setting

Steps

1. After entering the user pin, press the LED [#] button twice. Basic Features setting ON
2. Press LED [2] button, or press LED [5] button followed by [Registration] button and setting is complete

note

LED [2]: Dual-mode security authentication ON

note

LED [5]: Dual-mode security authentication OFF

note

The remote control, guest pin number, Bluetooth can open the deadbolt lock without secondary authentication

note

When the secondary authentication (card or fingerprint) of the user is not registered (or all of them are deleted), the deadbolt lock is released only by the user's primary authentication (pin number)

note

If the user's secondary authentication is not registered, dual-mode security authentication can not be turned on and the LED [2] button flashes with an error tone

note

double security authentication is ON and the secondary authentication of the registered user. If you delete all, dual-mode security authentication will be OFF