Skip to main content

Smart Card Registration

1. Card Registration (LED [2])​

Up to 200 cards per lock

Steps:

  1. Press R and enter main PIN + [#]
  2. LEDs [1] [2] [3] [4] [5] light up → press number [2]
  3. Place the Smart Card on the reader → beep sounds
  4. Press R → melody plays to confirm
tip
  • Smart Cards must be 13.56 MHz (FeliCa/Mifare)
  • Up to 200 cards can be registered
  • Registered cards are managed in the system

2. Smart Card Auto/Manual Recognition (LED [1] / [4])​

Set the Smart Card reading mode.

Steps:

  1. Touch the keypad to turn on LEDs
  2. Enter main PIN, then press [#]
  3. Press [1] for Auto or [4] for Manual
  4. Press R → melody plays to confirm
ModeBehavior
Auto (LED [1])Place card on reader → door opens immediately
Manual (LED [4])Must touch keypad first, then place card
caution
  • In Manual mode, if you don't touch the keypad first, the card won't be read
  • When Auto is set and FeliCa Auto-Detection is OFF, LED [2] will blink
  • LED [2] blinking + error tone = error

3. Door Open Alarm ON/OFF (LED [7])​

Set the alarm when door is left open.

Steps:

  1. Touch keypad → enter PIN + [#]
  2. Press [7] to toggle ON/OFF
  3. Press R to confirm

Behavior:

  • Enabled: When Door Open Alarm Mode is ON and Deadbolt Auto Lock is active, if the Latch/Magnet sensor is disconnected → beep 3 times every 7 seconds

⚠️ Cautions​

  • Registering more than 200 cards is rejected — delete old cards first
  • Card registration does NOT delete the main PIN
  • To delete all cards, use LED [2] in Deletion mode (press for 5 seconds)
  • If an error occurs, LED [2] will blink
  • Cards used with FeliCa Auto-Detection will be read automatically when in range
  • Smart Card + PIN = Dual Authentication