Fingerprint Registration
:::info Available on models with Fingerprint Reader ES-F300Dr, ES-F301D, ES-F500D/H, ES-F501D/H, ES-S510D/H, ES-FF730Gr, ES-FF731G, ES-S740D, ES-F7000Kr, ES-F9000Kr, ES-P8800K :::
Up to 100 fingerprints per lock
🖐 Register fingerprint (LED [3])
Steps:
- Press R and enter main PIN +
[#] - LEDs [1] [2] [3] [4] [5] light up → press number [3] (Fingerprint)
- Place finger on the sensor 4 times (~1 second each) — beep sounds each time
- On successful 4th scan → melody plays → fingerprint registered
- Press R to finish
📊 LED scan status
| LED | Meaning |
|---|---|
| LED [1] [2] [3] blinking [2] | 1st scan successful |
| LED [1] [2] [3] blinking [3] | 2nd scan successful |
| LED [1] [2] [3] blinking (no number) | 3rd scan successful |
| LED [0] lit | Error or finger not aligned |
💡 Fingerprint scanning tips
- Place finger fully on the sensor — not just the tip
- Finger must be clean — not wet, no lotion, no cuts
- Press gently — no need to press hard
- Children's or elderly fingerprints may scan poorly — use other authentication methods
⚠️ Cautions
warning
- One fingerprint per user — don't register the same finger twice
- If 4 scans fail → LED [0] lights → must start over
- All fingerprints are deleted if deleted via LED [3] in Deletion mode
- Fingerprint registration does NOT delete the main PIN
- 5 consecutive failed scans = Anti-Prank + 1-minute lockout
- Must register a valid fingerprint before using Dual Authentication
- Damaged/wet/cut fingerprints may fail to scan → use PIN instead